There aren't many people who have a torque wrench that can read that low.

OK

To save following my link above the torque value for the track rod end clamps is given as 10 lb ft.

Head off recently. How long has this been on, I wonder?
1969 88"

The clamps are only 1/4 UNF , I would think 20nm max 

^^^^

... and if you find a code not working, contact our Advertising Manager, Andy Phillipou who will investigate.

 

Not much for the clamps. 40nm should be about right.

In the back of Built to Last or in the members section of the Club website 

Yes, just tight (on the Wittsend scale) with a small spanner.

They should not, nor need to be gorilla tight 

You can find the "book" value HERE scroll down towards the end under torque settings.

 

Thanks all. I have the TREs and fitted them. No problem. Is there a torque setting?

Any discount codes any where at the moment? I have just talked to Paddock and they said yes, but what is it please?