NUTS

[DickB]

I have missing nuts (and a bolt) at the rear of the gear box/transfer box. Any idea the sizes?

Also, my speedo is dodgy so was going to replace the cable first while the floor is up. Are they all the same for the 2a?

[Tom]

The nut and bolt for the transfer top cover is 5/16"bsf x 1.29/32" long, with a spring washer and nut (also 5/16"bsf)
Part numbers 215170 for the bolt, 3075 for the washer, and 2828 for the nut.

The nut on the rear mainshaft bearing housing is 3/8" BSF.

[DickB]

that is fantastic. Sent the same picture to paddock spares and they were pretty unhelpful. So a big thanks Tom.

[W.Slow]

Hmm seems to be a common theme I too was short on quite a number of fasteners, whoever did my clutch in its recent history couldn't be bothered to fit the bottom half of nuts to the bell housing!!
Gearbox should all be BSF, BSW. So can't remember off the top of my head the dia of the output flange studs however I'm pretty sure the top gearbox cover to transfer box require 5/16 BSF nut and bolt.

[Genocache]

You guys DO know that the parts cataloque lists MOST nut and bolt sizes, don't you?